Rack Model Type 6061
AL
CP
TI
Fgr
Width
Fgr
Space
Rack
width
(Flat)
Lgth Form
Style
Hole
Style
22 30°
Notch,
.125"
Slot
.063"
.080"
.050" .625" .75" 7" 24"
36"
48"
Flat,
018,
019'
025
RK1
RK3
Suggested Use for 22-018 and 22-019 Racks

Model 22-018
The Models 22-018 and 22-019 Formed Split Finger Rack may be used to hold parts in the I.D. Bolt these racks to the same or opposite sides of the Spine, depending on the spacing required for he part.

Model 22-019
24 .25"
Tips,
.125"
Slot
.063"
.080"
.050" .625" .75" 7" 24"
36"
48"
Flat
Only
RK1
RK3
306SFN 45°
Notch,
.125"
Slot,
.125"
Tips
.063"
.080"
.050" 1" .125" 8" 18"
24"
36"
48"
Flat,
015
RK1
RK3
311SFN 30°
Notch,
.125"
Slot,
.312"
Tips
.063"
.080"
.050" 1.25" .125" 8" 18"
24"
36"
48"
Flat,
015
RK1
RK3
Suggested Use for 306SFN-05 and 311SFN-015 Racks
The Sequel Model 306SFN-015 Formed Split Finger Rack may be used to hold tubes up to 2 inches I.D. The 306SFN-015 is for tubes up to 2.5 inches I.D. Insert the tube over two of the rack fingers on the top rack, lift slightly and snap the part over two fingers on the bottom rack. The part will be sercurely held in place.