Rack, Split
Rack Model | Type | 6061 AL | CP TI | Fgr Width | Fgr Space | Rack width (Flat) | Lgth | Form Style | Hole Style | |
---|---|---|---|---|---|---|---|---|---|---|
22 | ![]() |
30° Notch, .125″ Slot | .063″ .080″ | .050″ | .625″ | .75″ | 7″ | 24″ 36″ 48″ | Flat, 018, 019′ 025 | RK1 RK3 |
24 | ![]() |
.25″ Tips, .125″ Slot | .063″ .080″ | .050″ | .625″ | .75″ | 7″ | 24″ 36″ 48″ | Flat Only | RK1 RK3 |
306SFN | ![]() |
45° Notch, .125″ Slot, .125″ Tips | .063″ .080″ | .050″ | 1″ | .125″ | 8″ | 18″ 24″ 36″ 48″ | Flat, 015 | RK1 RK3 |
311SFN | ![]() |
30° Notch, .125″ Slot, .312″ Tips | .063″ .080″ | .050″ | 1.25″ | .125″ | 8″ | 18″ 24″ 36″ 48″ | Flat, 015 | RK1 RK3 |
Suggested Use for 22-018 and 22-019 Racks

The Models 22-018 and 22-019 Formed Split Finger Rack may be used to hold parts in the I.D. Bolt these racks to the same or opposite sides of the Spine, depending on the spacing required for the part.

Suggested Use for 306SFN-05 and 311SFN-015 Racks
The Sequel Model 306SFN-015 Formed Split Finger Rack may be used to hold tubes up to 2 inches I.D. The 306SFN-015 is for tubes up to 2.5 inches I.D. Insert the tube over two of the rack fingers on the top rack, lift slightly and snap the part over two fingers on the bottom rack. The part will be securely held in place.
